Determining Gender

All too often rabbits are sexed incorrectly which can lead to accidental litters as well as serious fighting.

Sexing rabbits can be subject to operator error. The likely cause of the misidentification of a rabbit’s gender is simply not knowing exactly how to sex a rabbit.

It is not hard to tell male from female, but it is easy to make a mistake if you don't examine the bunnies carefully. This is because in little bucklings,

* Their equipment hasn’t descended, and

* Without sufficient pressure, the penile sheath does not protrude enough for you to tell the difference between buck and doe.

If you don’t apply enough pressure on the vent area for fear of hurting the bunny, nothing will protrude at all. That is where sexing rabbits can get tricky, but keep reading - we'll show you exactly how to determine the gender of a rabbit, whether a bunny or an adult rabbit. And we have included some great pictures to help you 'see' what to do.

How to tell a rabbit’s gender -

* Place the kit in your lap bottom side up. We place the head against our tummy and the tail towards our knees (see picture #7 below for the big view).

This is what you’ll see...

There’s not much difference in these pictures!

This is because the anus and the privates are normally scrunched together, like two doorways facing each other in a short hallway.

With the kits simply flipped over, you don’t see much of anything.

In these views, the vertical slit on the tail side is part of the anus, and the opening for the privates is tucked into the crevice and barely visible.

So here's what you do. Pinch the tail between the first two fingers, and place the thumb on the fur in the vent area.

Pull on the tail gently but firmly, and press downward on the vent with the thumb.

This will open up the works so you can tell what is what.

A wee boy -

You can see that a tubular structure is clearly protruding, and it has a circle opening.
Circle openings that protrude a lot equal bucks.

A little doe -

With a bit of firm pressure on the vent, you can see an opening that stretches to a slit without hardly protruding at all, even if you push a little harder with your thumb.

Linear openings that don't protrude hardly at all equal does.

Here is the key to getting it right:

Push with enough pressure that little boy protrusions do not stay hidden.
Do not be afraid to apply firm pressure, without pushing clear to the backbone, of course.

Here are a couple close-up pictures:

*Here’s how to hold them* -

Bottoms-up in our lap, head against our stomach and hind end towards the knees:

Determining the gender in older rabbits:

The gender of adult rabbits is much easier to identify. Again, at first glance, their hind ends don’t look all that different, because the openings are still facing each other.

On the adult buck, you can now see two long grayish areas on either side of the vent.

These are thinly furred scrotal sacs - a dead giveaway to his buckhood.

Applying the same techniques as we did to the bunnies, grasp the tail between your first two fingers and apply gentle but firm pressure to the vent with the thumb.

Here’s what you’ll see:

This is a buck.

If you happened to miss the scrotal sacs, a buck will offer an obvious protrusion from the vent.
It doesn’t take much pressure at all to reveal the privates.

This is a doe.

With the doe, nothing actually protrudes. As you apply firm pressure, you’ll discover the same slit you found on the bunny, and it will be easier to reveal it.
If it looks like there’s a bit of a protrusion, it is only because you are pressing downward on the vent.

Source: Sexing Rabbits
Further Reading:
Sexing Rabbits (Rabbit Gender Determination) - Pet Informed.

Desexing Info Pack

Diarrhoea